High Efficiency Diffuser Tubing

High Efficiency Diffuser Tubing

Producto n° 4845

Cotizar

High Efficiency Diffuser Tubing Aeration » Air Diffuser Tubing » Diffuser Tubing, High Efficiency This patented, low-pressure rubber/polyethylene diffuser hose is made for aquaculture. Step on it—it springs right back! This is efficient tubing, with a pressure resistance of only 12" of H2O at normal flow rates when new. Diffuser lengths of up to 20' per inlet are possible at low airflow rates. Tubing has a good oxygen transfer rate and is compatible with both regenerative blowers and linear air pumps. The gas flow rate is an average of .1-.5 cfm/ft; higher and lower flows are possible. Tubing produces a strong volume of medium-size bubbles (approximately 3 mm). For connections, use 1/2" barb fittings with clamps. Hose ends may be heat-sealed or fitted with a plug and clamp. To counteract buoyancy, hold-downs or weights are required. For best results, the tubing should be oriented with the blue stripe on the bottom. Inside diameter is 1/2" (13 mm); outside diameter is 1" (25 mm). Made in the USA by Colorite Plastics. Note: No warranty due to individual clogging and fouling possibilities.

Cotice: High Efficiency Diffuser Tubing

Productos Relacionados

Presencia de Aguamarket en Países como:

Chile Argentina Bolivia Colombia Costa Rica Cuba Ecuador El Salvador España Guatemala Honduras Mexico Nicaragua Panama Paraguay Perú Puerto Rico Republica Dominicana Uruguay Venezuela Francia Brasil Estados Unidos Canada Belice
www.alessmode.com