Cotiza tu Producto:

RUBBER POLY DIFFUSER TUBING   

  Imprimir
Cotizar y Comprar Rubber Poly Diffuser Tubing Cotizar y Comprar Rubber Poly Diffuser Tubing

Producto N° 6454
Rubber Poly Diffuser Tubing Aeration » Air Diffusers » This rugged rubber/polyethylene diffuser hose can take punishment. It springs right back even when walked on! The pressure resistance is approximately 4 psi (110" H2O), allowing a diffuser length of up to 30' per inlet. It is not compatible with regenerative blowers. Hold-downs or weights are required to counteract buoyancy. The gas flow rates shown are only an average. Much higher and lower flows are possible. It’s made with a special process to produce fine bubbles, making it a low-cost choice for diffusing pure oxygen. The lower cost 1/2" OD10 is a fine-pore diffuser, but produces somewhat larger and less uniform bubbles than the 1/4" OD4. It can be used with 3/8" barb fittings with clamps. Both are black. Hose ends may be heat sealed. OD10F and OD4 are sold by the foot, OD10R is a 100' roll. Made in USA.
COTICE: RUBBER POLY DIFFUSER TUBING
Email:
Confirmar Email:
Nombre de Contacto:
Pais:
Telefono:

Cód. País+Cód. Ciudad+Teléfono+Anexo
Tipo de Solicitud:
Detalle su solicitud:

Presencia de Aguamarket en Países como:

Chile Argentina Bolivia Colombia Costa Rica Cuba Ecuador El Salvador España Guatemala Honduras Mexico Nicaragua Panama Paraguay Perú Puerto Rico Republica Dominicana Uruguay Venezuela
Guinea Ecuatorial Filipinas Francia Brasil Estados Unidos Republica Arabe Saharaui Canada Gibraltar Andorra Belice Marruecos